Algema BLITZLADER 2, Руководство по эксплуатации, Страница: 61 / 108

Eder GmbH 4 Operation and running
Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021 61 / 108
4.10.2Wheel change
Eder GmbH does not supply any on-board tools for a flat tire as standard. It is necessary
to use the on-board tool of the base vehicle or to procure the tool externally.
• Changing wheels with a loaded vehicle is not permitted. Unload the car
transporter if necessary.
• Secure the car transporter against rolling away by engaging the parking brake and the
lowest gear or, in the case of automatic transmission, by moving the selector lever to
the P position.
•
•
•
Lift the defective wheel. It is recommended to use a maneuvering jack with a load
capacity of approx. 2000 kg for this purpose, as shown in the photo.
•
Jacks with a rubberized contact surface are advantageous. Alternatively, a piece of
anti-slip mat or similar can be placed on the support surface of the jack.
The jack must be placed under the longitudinal tube between the two rear axles as
shown. The jack must be positioned exactly in the center under the pivot point of the air
spring bellows.
•
Loosen the wheel bolts with a suitable tool by approx. half a turn before pumping
up the jack.
Then pump up the jack until both wheels of the affected side are approx. 3 cm above
the ground.
• Completely loosen the wheel bolts of the defective wheel.
•
Remove wheel from hub and place new wheel on hub.
•
Tighten the wheel bolts. Refer to the operating manual of the base vehicle for the
tightening torque. The tightening torque is identical on both rear axles. The wheel
bolts must be tightened crosswise.