Algema BLITZLADER 2, Руководство по эксплуатации

Страница: 75 / 108

5 Care and maintenance Eder GmbH
74 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
Undamaged rope of normal diameter, suitable for
use
If the rope cross-section is reduced by more than
10% due to wear. The
rope must be replaced!
A single strand emerges completely.
Reduction of the rope cross-section by more than
10% due to wear. The rope must be replaced!
fibers have buckled and a slight chiming can be
seen. This condition is not perma- nent and can
usually be remedied by stretching the rope.
Two rope strands lying next to each other have
snapped.
The rope must be replaced!
5.4.5 Changing illuminants
All standard taillights, the marker lights, license plate lighting, reflectors and the 13-pin
trailer socket* are integrated in a taillight bar.
Eder GmbH 5 Care and maintenance
Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021 75 / 108
Illuminant (from the outside to the inside):
Lighting Base Illuminant Power/Voltage
Marker light - LED 12 V
Flashing light BAU15s PY21 W 21 W / 12 V
Taillight
Brake light BAY15d P21/5W 21/5 W / 12 V
Reversing light BA15s P21W 21 W / 12 V
Rear fog light BA15s P21W 21 W / 12 V
License plate light SV8.5-8 Soffitte 5 W / 12 V
Changing the illuminant
•
•
• Unscrew the spreading disc with a Phillips screwdriver.
• Press the lamp with the bayonet catch into the holder, turn it slightly to the left and
remove it from the holder.
Insert new lamp in reverse order.
Screw the diffusing lens back on.
License plate lighting:
• Unscrew the cap with integrated diffusing lens using a Phillips screwdriver.
• Remove the lamp from the holder by pressing back the spring plates.
• Insert new bulb and screw cap back on.
The bulbs of the marker lights and side marker lights cannot be changed because they are
LED technology.