Algema BLITZLADER 2, Руководство по эксплуатации

Страница: 53 / 108

Eder GmbH 4 Operation and running
Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021 53 / 108
Lift third axis:
•
• Lifting the third axle is only allowed with an unloaded car transporter.
• To lift the third axis, the plateau must be fully tilted up. Therefore, it is
recommended to lift the axis immediately during unloading.
• To lift the axis when it is tilted up, pull the cable handle (2) firmly and hold the cable
handle (2).
• While the rope pull handle (2) is being pulled, the Plateau down button must be
pressed on the manual control panel (1) or on the active radio remote control* ( see "Tilt
plate au operation", page 21 ).
•
The tilting movement of the plateau causes a catch hook (3) to engage in the arresting
tube (4) and thus take the third axis up with it. There is one arresting hook and one
arresting tube each on the left and right.
Observe the third axis during tipping. As soon as the wheel of the third axis no longer
touches the ground, the rope pull handle (2) can be released.
Lower the third axis:
•
•
To lower the third axis, the plateau must be completely tilted up again. To do this,
press the Plateau up button on the manual control panel (1) or on the radio remote
control*.
• Due to the strong pendulum motion of the tandem undercarriage during tipping, the
arresting hook is released from the arresting tube with the aid of a tension spring after
the wheels of the third axle touch the ground. This releases the third axle without
further action. During tipping, the third axle remains on the ground.
If the third axis is to be lifted again after tipping up, the rope pull handle (2) must be
pulled during tipping down as described above.