Algema BLITZLADER 2, Руководство по эксплуатации

Страница: 42 / 108

4 Operation and running Eder GmbH
42 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
•
•
•
•
4.4 Radio remote control*
After switching on the setup functions on the touch panel ( see "Tilt plateau operation",
page 21 ), wait approx. 3-4 seconds (system self-diagnosis). Then press the Start key
(1). Alternatively, the radio remote control can also be activated by pressing the Radio
remote control button on the touch panel.
The radio remote control is active when the radio remote control button on the touch
panel lights up and the LED function indicators of the radio remote control flash (see
separate operating instructions for radio remote control).
• After the last command received, the radio remote control remains active for approx.
five minutes. It then switches off again. This is done by automatically activating
the emergency stop function.
Press the desired keys (2-4, 6-8) on the radio remote control to activate the
corresponding output on the receiver. The functions are analogous to the manual
control panel ( see "Tilt plateau operation", page 21 ). The buttons must remain pressed
during the work process.
To deactivate the radio remote control, press the Stop button (4). The button is
designed as an
emergency stop function.
In this state, all functions are switched
off. To reactivate the setup functions, see the "Emergency stop function" section.
Radio remote
control:
1. Start
2. Rope winch roll up
3. Plateau from
4. Ramps on
5. Stop (emergency
stop)
6. Cable winch
unwind
7. Plateau on
8. Ramps from