Alcatel-Lucent OmniAccess 700 CLI, Справочник по командам, Страница: 58 / 931

Introduction to CLI Modes
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
25
Alcatel-Lucent
Beta Beta
OmniAccess 700 CLI Command Reference Guide
Whereas, the Ctrl-C key combination ends your configuration session without
sending a Carriage Return signal. It does not save the changes into the running
configuration. In other words, it abruptly interrupts the process. For this reason, it
is safer to end your configuration session using the
End or the Ctrl-Z command.
E
XAMPLE
ALU# configure
Enter configuration commands, one per line. End with CNTL/Z.
ALU(config)# interface GigabitEthernet 7/0
ALU(config-if GigabitEthernet7/0)# ^Z
ALU#
ALU# configure
Enter configuration commands, one per line. End with CNTL/Z.
ALU(config)# interface GigabitEthernet 7/0
ALU(config-if GigabitEthernet7/0)# end
ALU#
ALU# configure
Enter configuration commands, one per line. End with CNTL/Z.
ALU(config)# interface GigabitEthernet 7/0
ALU(config-if GigabitEthernet7/0)# ^C
ALU#
ALU# configure
Enter configuration commands, one per line. End with CNTL/Z.
ALU(config)# interface GigabitEthernet 7/0
ALU(config-if GigabitEthernet7/0)# exit
ALU(config)#
ALU# configure
Enter configuration commands, one per line. End with CNTL/Z.
ALU(config)# interface GigabitEthernet 7/0
ALU(config-if GigabitEthernet7/0)# top
ALU(config)#
I
NITIAL
S
ETUP
Whenever the system configuration is empty, you are automatically entered into
the initial setup program, which takes you through the basic configuration steps.