Agromehanika AGS 2500 EN-HP, Инструкция по эксплуатации

Страница: 60 / 131

USER MANUAL – rev.2016/12 AGS 2500/3000 EN-HP
page
50
Figure 42: BOOM OPENING MECHANISM
For final setting of both hydraulic cylinders with booms of spraying equipment, both cylinder
have, on the fastening part, a limiting nut (pos. 1 – figure 42) with transverse safety bolts.
Limiting nut enables the cylinder to limit the position of boom closing, which is secured after
setting with counter-nut. End fitting on the hydraulic cylinder enables end position of open
equipment. When setting end fitting, first unscrew transverse bolts and then turn the piston
rod of cylinder to set desired position. Secure position by assembling transverse bolts.
10.7.9 Setting position of booms and opening bar
Parallelism and verticality of spraying equipment is set on foreseen places by
loosening/tightening the provided bolt connections and eye bearings. To ensure efficient
operation of spraying equipment, it is important that the booms are set correctly parallel.
Perform the setting on level ground, where the equipment must be open and set at convenient
height. Place a support under the lifting mechanism for safety reasons.
Boom 1:
Verticality of the first boom is set on eye bearings. Top bearing (pos. 2 – figure 43)
determines position in open position of equipment, and bottom eye bearing (pos. 3 – figure
43) determines position in closed equipment.
Boom parallelism to swing frame is set with bolt connection (pos. 1 – figure 43) on the rear
side of the boom, and with cylinder position (pos. 3 – figure 42) and position of end fitting on
cylinder (pos. 2 – figure 42).
2
1
3
3
2
1
Figure 43: SETTING FIRST BOOM