Agromehanika AGS 2500 EN-HP, Инструкция по эксплуатации

Страница: 112 / 131

USER MANUAL – rev.2016/12 AGS 2500/3000 EN-HP
page
102
12.4 Regulator maintenance
1. After each spraying, the regulator must be thoroughly washed with clean water,
because only this helps to keep the regulator in good condition, operation errors are
fewer, which reduces the costs of service.
2. Occasionally clean the external part of the regulator and grease rotating and sliding
parts. Most appropriate agent is WD-40 or similar maintenance agents.
3. During winter, all water must be emptied out of the regulator, the valves must be
left open or keep the regulator in a warm place. If you fill the sprayer during winter
with antifreeze or agent against freezing of windows, open valves and buttons on
valves to prevent freezing in dead, inaccessible places of the regulator.
4. It is obligatory to unscrew the pressure gauge and keep it in a warm place.
12.5 Parameters setting in AG-TRONIK program
Technicians of Agromehanika input parameters, required for spraying in AG-TRONIK and
save these parameters in factory setting. AG-TRONIK is accompanied with a sheet of
parameters – settings, input as factory settings.
If the speed sensor is installed subsequently or you have installed a speed sensor on tractor
wheel, then the parameter of speed constant is unknown and has to be input manually. See
chapter PROGRAMMING, SPEED CONSTANT, for help.
If you are connecting a non-standard
flow gauge to AG-TRONIK, consult
technical staff of Agromehanika.
CONNECTOR FOR CONNECTION
OF SPEED SENSOR
FLOW SENSOR CONNECTION