Agromehanika AGS 2500 EN-HP, Инструкция по эксплуатации

Страница: 100 / 131

USER MANUAL – rev.2016/12 AGS 2500/3000 EN-HP
page
90
11.8.5 General
Windows shows information about data transfer, settings... and is intended for servicing.
They are important for the user, if he wishes to reset AG-TRONIK to factory settings.
Enter window "GENERAL" by selecting icon and confirming it with confirmation
button . The display shows :
If you wish to restore AG-tronik to factory settings, hold button for approximately 4
seconds, until message "FACTORY SETTINGS?" is displayed.
If you do not want to restore it to factory settings, select and confirm "X" and window returns
to previous window.
If you want to restore it to factory settings, select "√" and the following parameters in AG-
tronik are reset to factory settings:
-
hectare dose
-
speed constant
-
flow constant
-
working width of individual sections and total width of spraying equipment
11.9 Printouts
11.9.1 Inserting SD card
AG-TRONIK writes analyses to SD memory card, which you received upon purchase of
automatic regulation. Writing to SD memory card is described in detail in the chapter 10
"ANALYSES", subchapter10.3 "WORK". On the left side of AG-TRONIK, where supply
cable is plugged in, there are two rubber covers. Under the top cover are fuses, and under the
bottom cover is a slot for SD memory card and connector for programming AG-TRONIK
(figure 84). If memory card is not inserted in the slot, insert it so that the front of the card
faces the front of AG-TRONIK. Insert the card all the way and release it. Remove SD card by
pushing the card all the way and releasing it. Then, pull the card out of the slot.