Agilent Technologies 8935 Series, Руководство пользователя

Страница: 64 / 343

Chapter 3 63
Troubleshooting
Functional Diagnostics (Step 2)
For descriptions of the diagnostic options, refer to:
• “Functional Diagnostics Menu” on page 66 .
• “AF Diagnostics” on page 68 .
• “RF Diagnostics” on page 70 .
• “CDMA Diagnostics” on page 72 .
Define Test Conditions
1. On the SOFTWARE MENU screen (see Figure 3-11 on page 65 ),
select
Execution Cond
to access the TESTS (Execution Conditions)
screen.
2. Set up the
Output Results To
: field. Select:
•
Crt
to view measurements only on the display.
•
Select Printer
to print the test results as well as display them
on the CRT.
3. Set the
Output Results For:
field to
All
4. Set up the
If Unit-Under-Test Fails:
field.
• Select
Continue
to continue to the next test point.
• Select
Stop
to pause testing at that point.
5. Set up the
Test Procedure Run Mode:
field.
• Select
Continuous
to run the tests continuously.
• Select
Single Step
to pause after each measurement.
6. Verify that the
Autostart Test Procedure on Power-Up:
setting
is
Off
.