Total Access 238 Command Line Interface Guide
56
61200630L1-35C
IMA PVC INTERFACE CONFIGURATION COMMAND SET
To activate the IMA PVC Configuration command set, enter the interface ima command at the
Global Configuration Mode prompt; then enter the pvc <VPI/VCI> command at the IMA
Interface Configuration Mode prompt. For example:
TA238#configure
TA238(config)#interface ima
TA238(config-ima)#pvc 0/35
TA238(config-ima-vc0/35)#
The following commands are common to multiple command sets and are covered in a
centralized section of this guide. For more information, refer to the sections listed below:
•
•
All other commands for this command set are described in this section in alphabetical order.
•
•
“ubr+ <peak cell rate> <min cell rate>”
•
