ADTRAN 1200630L1, Инструкция по интерфейсу

Страница: 16 / 92

Total Access 238 Command Line Interface Guide
2 61200630L1-35C
CLI INTRODUCTION
The basic concepts and strategies associated with using the Total Access 238 Command Line
Interface (CLI) Guide are presented in the following introductory sections:
• “Accessing the CLI from a PC or Terminal” on page 2
• “Understanding Configuration Modes” on page 2
• “Using CLI Shortcuts” on page 3
• “Performing Common CLI Functions” on page 4
• “Understanding CLI Error Messages” on page 4
Accessing the CLI from a PC or Terminal
The PNS management and provisioning features may be accessed by a CLI using the DB-9
CRAFT
interface located on the front panel of the unit.
To establish CLI communication with the PNS, perform the following steps:
1. Connect to the
CRAFT
interface using a VT100 dumb terminal or PC with VT100 emulation
software configured with the following parameters:
• Data rate: 9600 baud
• Data bits: 8
• Parity bits: 0
• Stop bits: 1
• No flow control
2. Once connected, press
E
NTER
to access the CLI.
3. Enter username and password at the login prompt.
• The default username is
admin
.
• The default password is
password
.
The TA238# prompt will display.
Understanding Configuration Modes
The Total Access 238 CLI has two configuration modes to organize the configuration
commands:
• Global
• Interface
Each configuration mode supports a set of commands specific to the allowable parameters for
the mode. For example, all IMA configuration commands are accessible only through the
Interface Configuration Mode (for the virtual IMA interface).
Table 1 describes the two configuration modes for the Total Access 238.