G 01063 - Edition 06 - December 06
1/4
B 130
Installation of exhaust heater accessory
Access to
the exhaust pipe
Facilities at the rear
(exhaust in horizontal position)
Remove the seal.
Remove the rear cover
unscrewing the 4 screws.
The exhaust pipe is located under
the pump.
When the main electrical switch on the top of the pump is set to “0“,
the part supply between the power plug and the main switch remains
energized.
Risk of electrical shock in case of contact.
Disconnect main electrical cable before servicing.
Check the electrical compatibility between accessory and main power
voltage.
Hazardous voltage enclosed.
Voltage or current hazard sufficient to cause shock.
Disconnect and lockout power before servicing.
Any intervention must be done by trained personnel only.
When the pump is switched off, internal parts (monitoring, frequency
converter) contain capacitors charged with over 60 VDC and remain
energized.
Electrical shock may result in severe injury.
Wait 1 minute after switching off before opening the pump.
Operating conditions may generate temperatures justifying particular
attention on the part of the user (external surfaces > 70°C on exhaust
connections).
Contact may cause burns.
Always use gloves before servicing.
HOT SURFACE
Contact may cause burn.
Do not touch or wear protective gear before
servicing.
WARNING
adixen Vacuum Products - Operating instructions - ADP/ADS Series Two
