ADEMCO VistaKey-SK, Инструкция по установке и настройке

Страница: 33 / 108

Section 4 – Detailed Installation
4–3
+ + + + + + + + + +
+
+
+
USE NYLON
WASHER UNDER
SCREW AT
THIS LOCATION.
+ +
POWER
SUPPLY
P/N SA12040
+
Figure 4-3: Installing the Power Supply
7. Remove the front cover from the VistaKey module.
8. The VistaKey module uses plug-in terminal blocks for TB-1 and TB3. Keeping the
terminal block screws toward the outside edge of the VistaKey module printed circuit
board, slide the terminal blocks onto the pins extending from the board.
9. Mount the VistaKey module into the cabinet by aligning the slots on the back of the
VistaKey module with the pins on the mounting plate and then sliding the VistaKey
module to the right. See Figure 4-4.
+ + + + + + + + + +
+
+
+ + +
VISTAKEY
MODULE
LOCATION
FOR
OPTIONAL
BATTERY
+
Figure 4-4: Installing the VistaKey module
•
Do not re-install the cover of the VistaKey module at this time. The cover is to be re-installed
according to instructions in later pages of this manual.
•
The area on the right side of the mounting plate may be used for a second VistaKey module.