ADEMCO VistaKey-SK, Инструкция по установке и настройке

Страница: 84 / 108

VistaKey Installation Guide
6–10
cardholder retains all rights and privileges that the VISTA user
number provided. These rights and privileges remain in effect
until such time as the cardholder is deleted from the system or
the card expires.
Press [
✲
] to accept the entry.
↓
VISTA Card ID Number
001 ACS Event?
Never Invoke
00
Enter two digits from the list below for the access point-related
event desired. Acceptable entries have the following meaning:
00 = never invoke 06 = egress grant
02= access request 07 = any grant
03 = egress request 08 = access denied
04 = any request 09 = egress denied
05 = access grant 10 = any denial
Press [
✲
] to accept the entry.
NOTES:
•
If you selected 00 “never invoke,” the system advances to the
“Block Entry” prompt.
•
For the ACS Event to occur, the card must be swiped at the access
point defined in the following prompt.
↓
VISTA Card ID Number
001 Access Point?
(01-15)
00
Enter 1 through 15 for the access point number corresponding to the
event defined above.
Press [
✲
] to accept the entry.
↓
VISTA Card ID Number
001 ACTION?
None
00
Enter two digits defining the action desired. For acceptable entries
and their meanings, see Table 5-1: Action Codes in the
Programming section of this manual.
NOTES:
•
For the Action to occur, the ACS Event (defined above) must have
been invoked by a card swipe at the access point defined in the
above prompt.
•
Actions that arm or disarm a partition will only be performed if
the VISTA user number (for the card) is assigned to the partition
to be armed or disarmed.
•
Action codes 60 (AP Exit Only), 66 (AP Group Exit Only), or 72
(AP Partition Exit Only) disable the entry reader at the access
point. The reader will remain disabled until a command is
received (via a keypad command or event) to protect the access
point.
Press [
✲
] to accept the entry.
In response to the action entered, the system displays a message
asking for additional information based on the action you selected.
For example, if the action you selected was 01 (relay on), the system
presents a message asking for a relay number. Respond to the
message and then press [
✲
] to accept the entry.