ADEMCO VistaKey-SK, Инструкция по установке и настройке

Страница: 88 / 108

VistaKey Installation Guide
6–14
NOTES:
•
Cardholders with VISTA user number of 000 can disarm
partitions to gain entry if they belong to an access group that
doesn't have an Armed Restriction for that partition. See “Setting
Up Access Groups” in the Programming section of this manual for
more information.
•
The system only accepts VISTA user numbers that have been
defined prior to entering #79 Card Function Programming.
•
Cardholders with VISTA user number of 000 will be identified as
U999 if the trace option is selected.
•
The partition rights and privileges of the VISTA user assigned
should be consistent with the partition rights and privileges
assigned to the card and to the access group to which the card
belongs.
•
If you assign a VISTA user number to a cardholder and
subsequently delete that VISTA user number from the panel, the
cardholder retains all rights and privileges that the VISTA user
number provided. These rights and privileges remain in effect
until such time as the cardholder is deleted from the system or
the card expires.
Press [
✲
] to accept the entry.
↓
VISTA Card ID Number
001 ACS Event?
Never Invoke
00
Enter two digits from the list below for the access point-related
event desired. Acceptable entries have the following meaning:
00 = never invoke 06 = egress grant
02= access request 07 = any grant
03 = egress request 08 = access denied
04 = any request 09 = egress denied
05 = access grant 10 = any denial
Press [
✲
] to accept the entry.
NOTES:
•
If you selected 00 “never invoke,” the system advances to the
“Block Entry” prompt.
•
For the ACS Event to occur, the card must be swiped at the access
point defined in the following prompt.
↓
VISTA Card ID Number
001 Access Point?
(01-15)
00
Enter 1 through 15 for the access point number corresponding to the
event defined above.
Press [
✲
] to accept the entry.
↓
VISTA Card ID Number
001 ACTION?
None
00
Enter the two-digit Action Number defining the action desired. For
acceptable entries and their meanings, see Table 5-1: Action Codes
in the Programming section of this manual.
NOTES:
•
For the Action to occur, the ACS Event (defined above) must have
been invoked by a card swipe at the access point defined in the
above prompt.
•
Actions that arm or disarm a partition will only be performed if
the VISTA user number (for the card) is assigned to the partition
to be armed or disarmed.