USER MANUAL
BEAT HF
Edition: January 2016
Revision: No. 4
MODE OF USE -
17
3.2.4 Using the barcode reader (not for BEAT HF-MV):
If you read the different data (operator’s ID, job ID, fitting, pipe, etc) by using optical
means (scanner), connect the reader device to the corresponding connector and put it in
front of the barcode data.
Laser scanner: When reading, the con
nected scanner emits a red laser ray of a
particular length. To read the barcode
data, place the scanner so that the laser
ray coincides longitudinally with the
barcode. The distance will depend on the
size of the barcode to be read. Once the
scanner has been placed in position, the
laser ray will stop flashing and remain
fixed. When this happens, press any of
the three buttons on the top of the scan-
ner.
Figure 10b: Example of using laser scanner
ATTENTION !
The scanner should be correctly setup. In case no data is captured by the
device, carry out the following barcode reading.
NOTE !
If none of the options on the setup menu have been enabled on BEAT
HF-Tr, such as operator’s ID, job’s ID, additional data or traceability,
skip clause 3.3 - TRACEABILITY and go directly to clause 3.4 -
ELECTROFUSION PROCESS.
