USER MANUAL
BEAT HF
Edition: January 2016
Revision: No. 4
MODE OF USE -
15
3.2
UNIT PREPARATION
3.2.1 Unit connection:
Connect the unit to a 230 V ± 15%/50-60 Hz mains source of
alternating current. For generator group specifications, please refer
to CHAPTER 6: TECHNICAL CHARACTERISTICS.
IMPORTANT NOTES !
Connection to a generator: the generator electric connection where
the electrofusion unit is plugged in must be normalized and fitted with
differential and ground pin. Refer to the generator’s User Manual.
Connection to the mains: the electric installation of the building where
the electrofusion unit is plugged in must be fitted with earth connection
as well as circuit breaker type D (EN 60898).
Do not unplug the mains by pulling on the cable.
3.2.2 Positioning of the unit in the work area (model 2008):
The control unit may be positioned according to the needs of the operator. It can be in a
fully vertical position (or even slightly tilted backwards) or tilted up to 20º off vertical.
Figure 9a: Fully vertical position
Figure 9b: Maximum tilted position
To alter the tilt of the unit casing, loosen the two side knobs, position according to need
and then tighten both knobs once again.
3.2.3 Start up of unit:
Set the master switch in the On position.
IMPORTANT NOTES !
Because the unit allows the use of an optic pen or scanner indistinctly,
connect the barcode reader to be used before switching on the unit so it
will be recognized.
Checking the terminals of the connecting cables to the fitting before
starting up the unit is advised. There are different types of adapters
depending on the type of fitting to be used. Refer to clause 3.4.1 Fitting
connection.
