ActronAir PKY470T-6Q2, Инструкция по установке и наладке

Страница: 9 / 80

9 ActronAir is constantly seeking ways to improve the design of it’s products, therefore specifications are subject to change without notice.
Copyright © 2017 Actron Engineering Pty. Ltd.
UNIT LIFTING PROCEDURES
EQUIPMENT REQUIRED FOR CRANE LIFTING:
- 4 x shackles - 2 x nylon slings - spreader bar
NOTE: Refer to catalogue for unit weight before selecting
shackles.
PROCEDURE:
1. Remove all screws and washers that secure the unit to the
timber pallet.
2. Use 4 x Bow or Dee shackles to connect the lifting holes.
3. Slip nylon slings through all shackles.
4. Ensure slings are protected by rubber pads or similar if
slings are draped across unit edges, corners, supply or
return air spigots. This will prevent the unit from being
damaged during lifting.
5. SPREADER BAR must be used when lifting the unit.
Lifting point is located in each corner of the
unit (4 total). SIZE: Ø25.4mm
LIFTING POINT
B. FORK LIFT METHOD
PROCEDURE:
1. To move the unit around with the pallet, it is required to insert the fork through the pallet (not the unit feet).
2. Only fork the unit through compressor end (see illustration for location of compressor end)
3. DO NOT use TINE EXTENSION to fork the unit.
4. The length of the fork lift tines need to be at least 1365mm in length in order to carry the unit.
5. Before lifting the unit, ensure the tines go past the center line of the unit.
NOTE: 1) Two pallet lifting locations shown below, fork lifting option 1 and option 2.
2) Ensure that the screws and washers are only removed when it is required to disassemble
the unit from the pallet.
COMPRESSOR
END
PALLET
PACKAGE UNIT
OPTION 1
OPTION 2
LIFTING THE
UNIT
FROM THE PALLET
LIFTING THROUGH PALLET
PALLET HOLE DIMENSIONS
INSERT FORK
LIFT TINES HERE
459
491
491
459
534 TYP
70
UNIT HOLE DIMENSIONS
All dimensions in mm.
A. CRANE LIFTING METHOD
NOTE:
Crane lifting is recommended over
fork lift method.
70
WH&S regulations must be observed and will
take precedent during lifting process.