ActronAir PKY470T-6Q2, Инструкция по установке и наладке

Страница: 19 / 80

19 ActronAir is constantly seeking ways to improve the design of it’s products, therefore specifications are subject to change without notice.
Copyright © 2017 Actron Engineering Pty. Ltd.
PRELIMINARY DATA ONLY
Version 5.01 140225
THIS LABEL TO BE REMOVED ON SIGN-OFF
19 ActronAir
®
is constantly seeking ways to improve the design of it’s products, therefore specifi cations are subject to change without notice.
Copyright © 2014 Actron Engineering Pty. Ltd.
UNIT PREPARATION
1. Remove Access Panel - Electrical
Remove mounting screws (4 pcs). •
Remove Access Panel - Electrical as shown in the •
above illustration
2. Remove Access Panel - Compressor
Remove mounting screws (4 pcs). •
Remove Access Panel - Compressor as shown in the •
above illustration.
3. Connect electrical and control wirings
Route electrical mains cable, indoor cable connections •
and wall control wires as shown above.
Refer to electrical section for electrical and control •
connections.
4. Assemble mains isolator components
Ensure the knob and isolator dial are both in OFF •
position.
Assemble shaft and knob in order as shown. •
Removal Order:
Pull-Out a bit
Pull-Down to remove
Access Panel-Electrical
A
B
A
B
B
Assembly Order:
Remove isolator cover plate.
Insert shaft.
Tighten screw to secure the shaft.
Install the knob/cover plate.
Ensure Shaft lines up with Isolator handle locating
slot & operates correctly when installed.
A
B
C
D
E
OFF
Position
OFF
Position
F
sition
Shaft key in
vertical position
A
B
C
D
Secure the cables fi rmly
using the cable ties and
clamp provided in the
panels.
Ensure Isolator Terminal
Shrouds are installed
after completing cable
termination.
UNIT PREPARATION
ELECTRICAL MAINS & ISOLATOR INSTALLATION