ActronAir PKY470T-6Q2, Инструкция по установке и наладке

Страница: 28 / 80

28
Installation & Commissioning Guide PKY470-700 Tri-Capacity Package with CM100 Control
Doc. No.0525-032
Ver. 9 180921
ELECTRICAL
Note: ActronAir Control Interface can be left connected
or can be dis-connected from the control board.
BMS PART NUMBERS
BMS Connection Type Kit Part Number *
MODBUS 485 ICMOD-485
BACNET 485 ICBAC-485
BACNET TCP/IP ICBAC-TCP-IP
* To be purchased separately.
BMS CONTROL INSTALLATION PROCEDURES
BMS Card
Vout
J9 FBus 1 J11 BMS2
GND
Tx/Rx
J14pLAN
J10
GND
Tx/Rx
J29FBus2
input 24V +10% -15% 50-60Hz / 28-36V
max power: 28W/20W
NO1
NC1 NC1
J16
J8
Out3
C2
J18
Out4
C2
J19
Out5
C2
J20
NO6
C6
J22
NO7
C7
J23
NO8
C8
J24
C2
V-IN
J21
Out2
C2
J17
J13
J12
J15
1
2
C11
NO11 NO12 NO13
J28
U8 U9 U10 +V
dc
+5VR GND
J5
DI7H DI7 DI7C DI8 DI8H
J25
GND Y1 Y2 Y3
J6
U1 U2 U3 GND
J2
D11 D12 D13 D14 GND
J7
U6 U7 +V
dc
+5VR GND
J4
46 U5 +V
dc
+5VR GND
J3
NO9
C9
NC9
NO10
C10
NC10
J27
Y4 Y5 U11 GND U12 GND D9 D10 DI9C
J26
G G0
J1
Connect BMS cable
into BMS kit
Optional BMS kit
(To be purchased separately)
STATIC SENSITIVE ELECTRONIC DEVICES !
DO NOT handle electronic devices unless you are wearing an Anti-Static Wrist Strap that is connected to a GOOD
EARTH. Failure to protect the electronic devices from static electricity may cause unrepairable damage.
Static damaged electronic devices are NOT COVERED for replacement under warranty.
CAUTION
Hazardous Voltage !
Always make sure that all power supply, including remote controls, are disconnected before performing maintenance.
Observe proper Lock-Out / Tag-Out procedures to ensure that power cannot be inadvertently energised. Failure to
disconnect power before maintenance procedures can result in serious injury or death.
Follow all electrical safety precautions when exposed to live electrical components.
Only qualified technicians are allowed to work on electrical circuits.
All electrical wiring must be in accordance with the relevant electrical authority rules and regulations.
DANGER