ACOEM Met One Instruments GAS-1060, Руководство пользователя

Страница: 67 / 164

Communications Page 67
Analyser Output 1 Output 2 Output 3
S50 SO
2
N/A N/A
S51 SO
2
H
2
S N/A
S55 H
2
S N/A N/A
S56 TS N/A N/A
S57 TRS N/A N/A
S60 NO
2
N/A N/A
Serinus Cal 3000 N/A O
3
N/A
4.4.1.1 Analog Outputs Voltage Calibration
Equipment Required

Multimeter (set to volts)

Male 25 pin connector with cable
Procedure
1. Open - Main Menu

Communications Menu

Analog Output Menu (refer to Section 3.4.25).
2. Select - Output Mode

Voltage .
3. Connect a multimeter (using an appropriate adaptor or probes on the multimeter) to the ground
(pin 24) and the relevant output pin (pin 10).
4. Edit - 0.5V Calibration - (until the multimeter reads 0.500 ±0.002) - Accept.
5. Edit - 5.0V Calibration - (until the multimeter reads 5.00 ±0.002) - Accept.
4.4.1.2 Analog Outputs Current Calibration
Equipment Required

Multimeter (set to mA)

Male 25 pin connector with cable
Procedure
1. Open - Main Menu

Communications Menu

Analog Output Menu (refer to Section 3.4.25).
2. Select - Output Mode

Current .
3. Connect a multimeter (using an appropriate adaptor or probes on the multimeter) to the ground
(pin 24) and the relevant output pin (pin 10).
4. Edit - 4mA Calibration - (until the multimeter reads 4mA ±0.01) - Accept.
5. Edit - 20mA Calibration - (until the multimeter reads 20mA ±0.01) - Accept.