ACOEM Met One Instruments GAS-1060, Руководство пользователя

Страница: 58 / 164

Serinus 60 User Manual 3.0
Page 58
Start-up Mode The following modes are available:
 NORMAL : In this mode nothing is done with the network
port during boot-up. It is assumed to be configured
correctly or unused.

READ IP : This mode interrogates the network port for its IP
address. The menu will display the network address after
boot-up.

SET IP : The user may enter an IP address, Netmask and
Gateway address (following the usual rules for formatting
these addresses). At this time the instrument does not
validate the correctness of these entries. When you cycle
power, the instrument will first instruct the network port
on its new address. It will switch to
Read IP mode and read
back the address it just set so the user may verify it in the
menu.

Set DHCP : This sets the network port into DHCP mode,
allowing the network to assign the instrument an IP
address.
IP Address
[Read or Set mode]
This is the current IP address of the instrument.
Netmask
[Read or Set mode]
This is the subnet mask of the network the instrument is
connected to.
Gateway
[Read or Set mode]
This is the IP address of the router to access addresses not on
the same subnet.
Adaptor is in DHCP mode
[DHCP mode]
In this mode the instrument will ask for its network
parameters from a DHCP server on your network.
Protocol Sets the protocol used for the network port ( Advanced ,
ModBus , EC9800 or Bayern-Hessen ). This must be set to
Advanced for Ecotech supplied software.
Endian
[Protocol Modbus]
Select Little or Big endian mode for ModBus protocol.
To read the IP address, perform the following steps:
1. Set the instrument to Read IP.
2. Manually cycle power off.
3. Wait three seconds.
4. Turn power on.
5. Read or set the IP address.
3.4.29 Bluetooth Menu
Main Menu

Communications Menu

Bluetooth Menu
This instrument supports Bluetooth communication through the Serinus Remote Android Application
(refer to Section 4.7).