3 Maintenance
3.3.6. Inspection, oil level gearbox axis 6
3HAC026876-001 Revision: F
134
© Copyri
ght
200
7-2010 ABB.
All rights reserved.
Inspection, oil level gearbox 6, wrist type 1
Use this procedure to inspect the oil level in gearbox axis 6, for wrist type 1.
Action
Note
1.
WARNING!
Handling gearbox oil involves several safety risks.
Before proceeding, please read the safety
information in the section
during work with gearbox lubricants (oil or grease)
on page 44
.
2.
DANGER!
Turn off all electric power, hydraulic and pneumatic
pressure supplies to the robot!
For Foundry Prime robots:
Do not turn off the air pressure to motors and SMB.
3. Make sure the oil plug, filling is facing upwards and
open it.
Shown in the figure
4. Turn axis to 85 degrees. Oil should now start to run
over. To much oil will give overrun before 85
degrees, to little oil in axis means oil will not spill
over until after 85 degrees.
5. Add oil if required.
Further information about how to
fill the oil may be found in the
section
.
6. Refit the oil plug, filling.
Tightening torque: 24 Nm.
7.
WARNING!
Do not mix the oil types. If wrong oil is refilled, the
gearbox must be rinsed as detailed in the section
Type of oil
.
Continued
Continues on next page
Содержание IRB 6640
