ABB FDNA-01, Руководство пользователя

Страница: 34 / 168

34 Start-up
Drive configuration
The following information applies to all drive types compatible with
the adapter module, unless otherwise stated.
„
DeviceNet connection configuration
After the adapter module has been mechanically and electrically
installed according to the instructions in chapters Mechanical
installation and Electrical installation , the drive must be prepared
for communication with the module.
The detailed procedure of activating the module for DeviceNet
communication with the drive depends on the drive type. Normally,
a parameter must be adjusted to activate the communication. See
the drive-specific start-up procedures starting on page 49 .
Once communication between the drive and the adapter module
has been established, several configuration parameters are copied
to the drive. These parameters are shown in the tables below and
must be checked first and adjusted where necessary.
Note: Not all drives display descriptive names for the configuration
parameters. To help you identify the parameters in different drives,
the names displayed by each drive are given in grey boxes in the
tables.
Note: The new settings take effect only when the adapter module
is powered up the next time or when the fieldbus adapter refresh
parameter is activated.
Note: If communication between the adapter module and
DeviceNet master is established, changes to the configuration
parameters can be done also through Fieldbus configuration object
91h .