ABB ACS880 N5700 Series, Руководство по прошивке, Страница: 343 / 662

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
8 PTC sensor connected to digital input DI6 (see the
connection diagram on page
111 ).
Note: Either 0 ohm (normal temperature) or 4000 ohm
(excessive temperature) will be shown by
35.2 Measured
temperature 1 . By default, an excessive temperature
will generate a warning as per parameter 35.13
Temperature 1 warning limit . If you want a fault instead,
set 35.12 Temperature 1 fault limit to 4000 ohm.
PTC DI6
20 PTC sensor connected to a standard analog input
selected by parameter
35.14 Temperature 1 AI source
and an analog output. The input and output can be on
the drive control unit or on an extension module.
The required settings are the same as with selection
KTY84 analog I/O , except that the source selection
parameter of the analog output must be set to Force
PTC excitation .
PTC analog I/O
9 PTC sensor connected to encoder interface 1.
See also parameters
91.21 Module 1 temp sensor type
and 91.22 Module 1 temp filter time .
PTC encoder module
1
10 PTC sensor connected to encoder interface 2.
See also parameters
91.24 Module 2 temp sensor type
and 91.25 Module 2 temp filter time .
PTC encoder module
2
11 The temperature is taken from the source selected by
parameter
35.14 Temperature 1 AI source . The value of
the source is assumed to be in the unit of temperature
specified by
96.16 Unit selection .
Direct temperature
13 Pt1000 sensor connected to a standard analog input
selected by parameter
35.14 Temperature 1 AI source
and an analog output. The input and output can be on
the drive control unit or on an extension module.
The required settings are the same as with selection
KTY84 analog I/O , except that the source selection
parameter of the analog output must be set to Force
Pt1000 excitation .
1 x Pt1000 analog
I/O
14 As selection 1 x Pt1000 analog I/O , but with two sensors
connected in series. Using multiple sensors improves
measurement accuracy significantly.
2 x Pt1000 analog
I/O
15 As selection 1 x Pt1000 analog I/O , but with three
sensors connected in series. Using multiple sensors
improves measurement accuracy significantly.
3 x Pt1000 analog
I/O
16 Pt1000 sensor connected to encoder interface 1. See
parameters
91.21 Module 1 temp sensor type and 91.22
Module 1 temp filter time .
Note: Pt1000 sensor supports FEN-11 and FEN-31
encoder modules only.
Pt1000 encoder
module 1
Parameters 343