3D Systems CubePro 3D Printer, Руководство пользователя, Страница: 92 / 110

prints the middle scale so the scales of print jets 2 and 3 can be easily compared to it. Print jet 2 prints
above print jet 1 and print jet 3 prints below print jet 1. For printers with only two (2) print jets, the scale
below the print jet 1 scale will not be printed.
The lines on the calibration print represent an offset of 0.1 mm and should be measured from the printed
arrows in the center of the scales.
Reading the Offset Jets Scale
Note the white arrow printed from print jet 2 and compare it to the positioning of the blue arrow printed by
print jet 1. Note that the white arrow is slightly left of the blue arrow meaning that print jet 2 is misaligned.
Print jet 2 must be moved in a positive direction (right) to align with print jet 1.
Compare the printed lines of print jet 1 and 2 to the right of the arrows and find the printed lines that are
properly aligned. In this illustration, the lines at +0.3 are aligned. This means that the offset must be
corrected by increasing the offset by .3 mm.
When comparing the arrow printed by print jet 3 to the arrow printed by print jet 1, notice it is positioned
slightly to the right. This means it must be adjusted in a negative (left) direction. Compare the lines of print
jet 1 and 3 to the left of the center arrows and find the printed lines that are properly aligned, In this
illustration, the lines at -0.3 are aligned. This means that the offset must be corrected by decreasing the
offset by .3 mm.
Offset Jets Calibration Procedure
The following procedure demonstrates calibrating print jets 1 and 2 on the X-axis. Calibrating the Y-axis is
the same procedure. The illustration below will be used for demonstration purposes. Be sure to refer to the
actual scale printed by your printer and adjust the settings accordingly.