1-20
To do…
Use the command…
Remarks
Configure a static LSP taking
the current LSR as the ingress
static-lsp
ingress lsp-name
destination dest-addr
{
mask
|
mask-length
}
nexthop
next-hop-addr
out-label
out-label
Optional
Configure a static LSP taking
the current LSR as a transit
LSR
static-lsp transit
lsp-name
incoming-interface
interface-type interface-number
in-label in-label
nexthop
next-hop-addr
out-label
out-label
Optional
Configure a static LSP taking
the current LSR as the egress
static-lsp egress lsp-name
incoming-interface
interface-type interface-number
in-label
in-label
Optional
z
If you specify the next hop when configuring a static LSP, and the address of the next hop is
present in the routing table, you also need to specify the next hop when configuring the static IP
route.
z
The value of the
next-hop-addr
argument cannot be any local public network IP address.
z
For information about configuring a static IP route, refer to
Static Routing Configuration
in the
IP
Routing Volume
.
Configuring MPLS LDP
Configuration Prerequisites
Before configuring LDP, be sure to complete the following task:
z
Configuring MPLS basic capability.
MPLS LDP Configuration Task List
Complete the following tasks to configure LDP:
Task
Remarks
Configuring MPLS LDP Capability
Required
Configuring Local LDP Session Parameters
Optional
Configuring Remote LDP Session Parameters
Optional
Configuring the Policy for Triggering LSP Establishment
Optional
Configuring the Label Distribution Control Mode
Optional
Configuring LDP Loop Detection
Optional
Configuring LDP MD5 Authentication
Optional
Содержание S7902E
