3Com S7902E, Руководство по настройке

Страница: 662 / 2621

1-29
To do… Use the command… Remarks
Configure the OSPF network
type for the interface as P2MP ospf network-type p2mp
[ unicast ]
Required
By default, the network type of an
interface depends on the link
layer protocol.
After you configure the OSPF
network type for an interface as
P2MP unicast, all packets are
unicast over the interface. Thus
the interface cannot broadcast
hello packets to discover
neighbors. In that case, you need
to manually specify the IP
address of the neighboring
interface.
Exit to system view quit —
Enter OSPF view
ospf [ process-id | router-id
router-id | vpn-instance
instance-name ] *
—
Specify a neighbor and its DR
priority on a P2MP unicast
network
peer ip-address [ cost value |
dr-priority dr-priority ]
Required if the interface type is
P2MP unicast
Configuring the OSPF Network Type for an Interface as P2P
Follow these steps to configure the OSPF network type for an interface as P2P:
To do… Use the command… Remarks
Enter system view system-view
—
Enter interface view
interface interface-type
interface-number
—
Configure the OSPF network
type for the interface as P2P
ospf network-type p2p
Required
By default, the network type of an
interface depends on the link
layer protocol.
Configuring OSPF Route Control
This section covers how to control OSPF routing information advertisement and reception, and route
redistribution from other protocols.
Prerequisites
Before configuring this task, you have configured:
z
IP addresses for interfaces
z
OSPF basic functions
z
Corresponding filters if routing information filtering is needed.