3Com S7902E, Руководство по настройке

Страница: 138 / 2621

1-7
Task Remarks
Configuring the Management Address and Its Encoding Format Optional
Setting Other LLDP Parameters Optional
Setting an Encapsulation Format for LLDPDUs Optional
Configuring CDP Compatibility Optional
Configuring LLDP Trapping Optional
LLDP-related configurations made in Ethernet interface view takes effect only on the current port, and
those made in port group view takes effect on all ports in the current port group.
Performing Basic LLDP Configuration
Enabling LLDP
To make LLDP take effect on certain ports, you need to enable LLDP both globally and on these ports.
Follow these steps to enable LLDP:
To do… Use the command… Remarks
Enter system view system-view —
Enable LLDP globally lldp enable
Required
By default, LLDP is disabled
globally.
Enter Ethernet
interface view interface interface-type
interface-number Enter
Ethernet
interface
view or port
group view
Enter port
group view port-group manual
port-group-name
Required
Use either command.
Enable LLDP lldp enable
Optional
By default, LLDP is enabled on
a port.
Setting LLDP Operating Mode
LLDP can operate in one of the following modes.
z
TxRx mode. A port in this mode sends and receives LLDP frames.
z
Tx mode. A port in this mode only sends LLDP frames.
z
Rx mode. A port in this mode only receives LLDP frames.
z
Disable mode. A port in this mode does not send or receive LLDP frames.
Follow these steps to set LLDP operating mode: