3Com S7902E, Руководство по настройке

Страница: 76 / 2621

1-2
To do… Use the command… Remarks
Assign the port or ports
to the isolation group as
an isolated port or ports
port-isolate enable
Required
No ports are added to the isolation group
by default.
After you configure a command on a Layer-2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do that
on the aggregate interface, it stops applying the configuration to the aggregation member ports. If it fails
to do that on an aggregation member port, it simply skips the port and moves to the next port.
Displaying and Maintaining Isolation Groups
To do… Use the command… Remarks
Display the isolation group
information on a
single-isolation-group device
display port-isolate group Available in any view
Port Isolation Configuration Example
Network requirements
z
Users Host A, Host B, and Host C are connected to GigabitEthernet 2/0/1, GigabitEthernet 2/0/2,
and GigabitEthernet 2/0/3 of Device.
z
Device is connected to the Internet through GigabitEthernet 2/0/4.
z
GigabitEthernet 2/0/2, GigabitEthernet 2/0/3, and GigabitEthernet 2/0/4 belong to VLAN 2 and
GigabitEthernet 2/0/1 carries VLAN 2.
It is required that Host A, Host B, and Host C can access the Internet while being isolated from one
another.