ZyXEL Communications Prestige 653HWI series, User Manual

Page: 458 / 564

Prestige 653HWI Series User’s Guide
43-8 VPN/IPSec Setup
Table 43-2 Menu 27.1.1 IPSec Setup
FIELD DESCRIPTION EXAMPLE
Secure
Gateway
Address Type the IP address or the domain name (up to 31 characters) of the
IPSec router with which you’re making the VPN connection.
Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN IP
address (the
Key Management field must be set to IKE , see later).
Zw50test.com.
tw
Protocol Enter 1 for ICMP, 6 for TCP, 17 for UDP, etc. 0 is the default and signifies
any protocol. 0
Local Local IP addresses must be static and correspond to the remote IPSec
router’s configured remote IP addresses.
Two active SAs cannot have the local and remote IP address(es) both the
same. Two active SAs can have the same local or remote IP address, but
not both. You can configure multiple SAs between the same local and
remote IP addresses, as long as only one is active at any time.
Addr Type Press [SPACE BAR] to choose SINGLE , RANGE , or SUBNET and press
[ENTER]. Select SINGLE with a single IP address. Select RANGE for a
specific range of IP addresses. Select SUBNET to specify IP addresses on
a network by their subnet mask.
SINGLE
IP Addr Start When the Addr Type field is configured to Single , enter a static IP
address on the LAN behind your Prestige.
When the Addr Type field is configured to Range , enter the beginning
(static) IP address, in a range of computers on your LAN behind your
Prestige.
When the Addr Type is configured to SUBNET , this is a (static) IP
address on the LAN behind your Prestige.
192.168.1.35
End/Subnet
Mask
When the Addr Type field is configured to Single , this field is N/A .
When the Addr Type field is configured to Range , enter the end (static) IP
address, in a range of computers on the LAN behind your Prestige.
When the Addr Type field is configured to SUBNET , this is a subnet mask
on the LAN behind your Prestige.
192.168.1.38
Port Start 0 is the default and signifies any port. Type a port number from 0 to 65535.
You cannot create a VPN tunnel if you try to connect using a port number
that does not match this port number or range of port numbers.
Some of the most common IP ports are: 21, FTP; 53, DNS; 23, Telnet; 80,
HTTP; 25, SMTP; 110, POP3
0