ZyXEL Communications Prestige 653HWI series, User Manual

Page: 326 / 564

Prestige 653HWI Series User’s Guide
28-6 Internet Access
Table 28-2 Menu 4 Internet Access Setup
FIELD DESCRIPTION EXAMPLE
Multiplexing
Press [
SPACE BAR
] to select the method of multiplexing
used by your ISP. Choices are VC-based or LLC-based .
LLC-based
VPI # Enter the Virtual Path Identifier (VPI) assigned to you. 8
VCI # Enter the Virtual Channel Identifier (VCI) assigned to you. 35
Service Name When using PPPoE encapsulation, type the name of your
PPPoE service here.
My Login Configure the My Login and My Password fields for PPPoA
and PPPoE encapsulation only. Enter the login name that your
ISP gives you. If you are using PPPoE
encapsulation , then this
field must be in the form user@domain where domain
identifies your PPPoE service name.
N/A
My Password Enter the password associated with the login name above. N/A
Idle Timeout
( PPPOE only)
This value specifies the number of idle seconds that elapse
before the Prestige automatically disconnects the PPPoE
session. 0
NAT
Press [
SPACE BAR
] to select None , SUA Only or Full
Feature . Please see the NAT Chapter for more details on
NAT.
SUA Only
Address Mapping Set Type the numbers of mapping sets (1-8) to use with NAT. See
the
NAT chapter for details.
N/A
IP Address
Assignment
Press [
SPACE BAR
] to select Static or Dynamic address
assignment.
Dynamic
IP Address Enter the IP address supplied by your ISP if applicable. N/A
ENET ENCAP
Gateway Enter the gateway IP address supplied by your ISP when you
are using
ENET ENCAP encapsulation.
N/A
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
If all your settings are correct your Prestige should connect automatically to the Internet. If the connection
fails, note the error message that you receive on the screen and take the appropriate troubleshooting steps.