ZyXEL Communications Prestige 653HWI series, User Manual

Page: 301 / 564

Prestige 653HWI Series User’s Guide
Menu 2 WAN Backup Setup 25-9
Figure 25-7 Menu 2.2.2 NetCAPI Setup
The following table describes the fields in this menu.
Table 25-4 Menu 2.2.2 NetCAPI Setup
FIELD DESCRIPTION
Active Select Yes to enable NetCAPI.
Max Number of
Registered Users When you want to use NetCAPI to place outgoing calls or to listen to incoming
calls, you must start RVSCOM on your computer, and RVSCOM will register
itself to the Prestige. Enter the maximum number of clients that you want the
Prestige to support at the same time.
Incoming Data Call
Number Matching
This field determines how incoming calls are routed. Select NetCAPI if you want
to direct all incoming data calls to NetCAPI. Select Subscriber Number (MSN) if
you want to direct incoming calls to the Prestige only when the incoming phone
number matches the ISDN DATA number. If the incoming phone number does
not match the ISDN DATA number, then the call will be routed to NetCAPI.
Select
Called Party Subaddress if you want to direct all incoming calls to the
Prestige only when the incoming call matches the subaddress of ISDN DATA. If
the incoming call does not match the subaddress of ISDN DATA, then the call
will be routed to NetCAPI.
Access List: This access list controls if a client is allowed to use NetCAPI. The request is
rejected when either the IP address of the computer is not between Start IP and
End IP or the request from the computer is not permitted as specified in the
Operation field.
Menu 2.2.2 - NetCAPI Setup
Active= No
Max Number of Registered Users= 1
Incoming Data Call Number Matching= Multiple Subscriber Number (MSN)
Access List:
Start IP End IP Operation
0.0.0.0 0.0.0.0 None
0.0.0.0 0.0.0.0 None
0.0.0.0 0.0.0.0 None
0.0.0.0 0.0.0.0 None
0.0.0.0 0.0.0.0 None
0.0.0.0 0.0.0.0 None
0.0.0.0 0.0.0.0 None
0.0.0.0 0.0.0.0 None
default None
Press ENTER to Confirm or ESC to Cancel: