ZyXEL Communications AAM1212-51, User Manual

Page: 407 / 435

AAM1212-51/53 Series User’s Guide
Chapter 54 ACL Commands 407
C
H A P T E R
54
ACL Commands
An ACL (Access Control Logic) profile allows the system to classify and perform actions on
the upstream traffic. Use the ACL Profile commands to set up ACL profiles and the ACL
Assignment commands to apply them to PVCs.
54.1 ACL Profile Commands
Use these commands to set up ACL profiles.
54.1.1 ACL Profile Set Command
Syntax:
ras> switch acl profile set <name> <rule> <action>
where
This command configures an ACL rule to classify the upstream traffic and perform action(s)
on the classified traffic.
The following lists the set of criteria you can configure for rules in ACL profiles. The rules are
listed in sequence from highest priority to lowest priority. The criteria within a rule are
position-independent.
•
etype <etype> vlan <vid>
•
etype <etype> smac <mac>
•
etype <etype> dmac <mac>
<name> =
The name of the ACL profile.
<rule> =
The rule that classifies traffic flows. See below.
<action> =
One or more actions to perform on the classified packets. You
can select one or more of the following actions.
• rate <rate > = Sets the transmission rate (1~65535 in kbps) for
the matched traffic.
•
rvlan <rvlan>
= Replaces the VLAN ID with this VLAN ID
(1~4094).
• rpri <rpri> = Replaces the priority with this priority (0 ~7) of
the matched packets.
•
deny
= Drops the packets.