ZyXEL Communications AAM1212-51, User Manual

Page: 193 / 435

AAM1212-51/53 Series User’s Guide
Chapter 27 2684 Routed Mode 193
Figure 99 2684 Routed PVC
The following table describes the labels in this screen.
Table 59 2684 Routed PVC
LABEL DESCRIPTION
Routed Domain Click Routed Domain to open this screen where you can configure domains for
2684 routed mode traffic (see Section 27.3 on page 194 ).
RPVC ARP Proxy Click RPVC ARP Proxy to go to the screen where you can view the Address
Resolution Protocol table of IP addresses of CPE devices using 2684 routed
mode and configure how long the device is to store them (see Section 27.4 on
page 195 ).
Routed Gateway Click Routed Gateway to go to the screen where you can configure gateway
settings (see Section 27.5 on page 196 ).
Port Use this drop-down list box to select a port for which you wish to configure
settings.
Gateway IP Enter the IP address of the gateway to which you want to send the traffic that the
system receives from this PVC. Enter the IP address in dotted decimal notation.
VPI Type the Virtual Path Identifier for this routed PVC.
VCI Type the Virtual Circuit Identifier for this routed PVC.
IP Enter the subscriber’s CPE WAN IP address in dotted decimal notation.
NetMask The bit number of the subnet mask of the subscriber’s WAN IP address. To find
the bit number, convert the subnet mask to binary and add all of the 1’s together.
Take “255.255.255.0” for example. 255 converts to eight 1’s in binary. There are
three 255’s, so add three eights together and you get the bit number (24).
Make sure that the routed PVC’s subnet does not include the AAM1212’s IP
address.
DS VC Profile Use the drop-down list box to select a VC profile to use for this channel’s
downstream traffic shaping.
US VC Profile Use the drop-down list box to select a VC profile to use for this channel’s
upstream traffic. The AAM1212 does not perform upstream traffic policing if you
do not specify an upstream VC profile.
Add Click Add to save your changes to the AAM1212’s volatile memory.
The AAM1212 loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to start configuring the screen again.
Index This field displays the number of the routed PVC.