ZyXEL Communications AAM1212-51, User Manual

Page: 252 / 435

AAM1212-51/53 Series User’s Guide
252 Chapter 41 Commands
41.3 Saving Your Configuration
Use the following command to save your configuration when you are done with a
configuration session.
ras> config save
Note: Do not turn off your AAM1212 while saving your configuration.
This command saves all system configurations to nonvolatile memory. You must use this
command to save any configuration changes that you make, otherwise the AAM1212 returns
to its default settings when it is restarted. Save your changes after each configuration session.
Nonvolatile memory refers to the AAM1212’s storage that remains even if the AAM1212’s
power is turned off. Run-time (memory) is lost when the AAM1212’s power is turned off.
41.4 Commands
The following table lists commands that you can use with the AAM1212.
The P column on the right indicates the administrator privilege level needed to use the
command ( H for high, M for middle or L for low) and the equivalent in the web configurator
( H for high or L for low).
Table 88 Commands
CLASS COMMAND PARAMETERS DESCRIPTION P
sys
info show
Displays general system
information.
L/L
info hostname <hostname> Sets the system name. M/L
info location <location>
Sets location information. M/L
info contact <contact>
Sets contact person information. M/L
reboot [show|sec|cancel] Sets the reboot timer or displays
the timer and remaining time for
reboot. If a reboot has been
scheduled, use this command to
prevent a reboot.
H/H
snmp show
Displays SNMP settings. M/L
snmp getcommunity <community> Sets the SNMP GetRequest
community.
H/H
snmp setcommunity <community>
Sets the SNMP SetRequest
community.
H/H
snmp trapcommunity <community>
Sets the SNMP Trap community. H/H
snmp trusthost <ip>
Sets the SNMP trusted host. Set
0.0.0.0 to trust all hosts.
H/H