ZyXEL Communications AAM1212-51, User Manual

Page: 201 / 435

AAM1212-51/53 Series User’s Guide
Chapter 28 PPPoA to PPPoE 201
Priority Use the drop-down list box to select the priority value (0 to 7) to add to incoming
frames without a (IEEE 802.1p) priority tag.
AC Name This field is optional. Specify the hostname of a remote access concentrator if
there are two access concentrators (or BRAS) on the network or if you want to
allow PAE translation to the specified access concentrator. In this case, the
AAM1212 checks the AC name field in the BRAS's reply PDU. If there is a
mismatch, the AAM1212 drops this PDU. (This is not recorded as an PPPoE AC
System Error in the PPPoA to PPPoE Status screen, however.)
Service Name This field is optional. Specify the name of the service that uses this PVC. This
must be a service name that you configure on the remote access concentrator.
Hellotime Specify the timeout, in seconds, for the PPPoE session. Enter 0 if there is no
timeout.
Apply Click this to add or save channel settings on the selected port.
This saves your changes to the AAM1212’s volatile memory. The AAM1212
loses these changes if it is turned off or loses power, so use the Config Save
link on the navigation panel to save your changes to the non-volatile memory
when you are done configuring.
Cancel Click Cancel to start configuring the screen again.
Show Port Select which DSL port(s) for which to display PPPoA to PPPoE conversion
settings.
Index This field displays the number of the PVC. Click a PVC’s index number to open
the screen where you can look at the current status of this PPPoA-to-PPPoE
conversion. (See Section 28.3 on page 202 .)
Note: At the time of writing, you cannot edit the VPI and VCI. If
you want to change them, add a new PVC with the desired
settings. Then, delete any unwanted PVCs.
Port This field displays the number of the DSL port on which the PVC is configured.
VPI/VCI This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier
(VCI). The VPI and VCI identify a channel on this port.
PVID This is the PVID (Port VLAN ID) assigned to untagged frames or priority frames
(0 VID) received on this channel.
Priority This is the priority value (0 to 7) added to incoming frames without a (IEEE
802.1p) priority tag.
Hellotime This field displays the timeout for the PPPoE session, in seconds.
DS / US VC Profile This shows which VC profile this channel uses for downstream traffic shaping.
The VC profile for upstream policing also displays if the channel is configured to
use one.
Access Concentrator
Name
This field displays the name of the specified remote access concentrator, if any.
Service Name This field displays the name of the service that uses this PVC on the remote
access concentrator.
Select
Delete Select the check box in the Select column for an entry, and click Delete to
remove the entry.
Select All Click this to select all entries in the table.
Select None Click this to un-select all entries in the table.
Table 63 PPPoA to PPPoE (continued)
LABEL DESCRIPTION