ZyXEL Communications AAM1212-51, User Manual

Page: 197 / 435

AAM1212-51/53 Series User’s Guide
Chapter 27 2684 Routed Mode 197
Figure 102 2684 Routed Gateway
The following table describes the labels in this screen.
Table 62 2684 Routed Gateway
LABEL DESCRIPTION
Routed PVC Click Routed PVC to go to the screen where you can configure routed PVC
settings (see Section 27.2 on page 192 ).
Routed Domain Click Routed Domain to open this screen where you can configure domains for
2684 routed mode traffic (see Section 27.3 on page 194 ).
RPVC ARP Proxy Click RPVC ARP Proxy to go to the screen where you can view the Address
Resolution Protocol table of IP addresses of CPE devices using 2684 routed
mode and configure how long the device is to store them (see Section 27.4 on
page 195 ).
Gateway IP Enter the IP address of the gateway to which you want to send the traffic that the
system receives from this PVC. Enter the IP address in dotted decimal notation.
VID Specify a VLAN Identifier to add to Ethernet frames that the system routes to this
gateway.
Priority Select the IEEE 802.1p priority (0~7) to add to the traffic that you send to this
gateway.
Add Click Add to save your changes to the AAM1212’s volatile memory.
The AAM1212 loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Index This field displays the number of the gateway entry.
Gateway IP This field displays the IP address of the gateway.
VID This field displays the VLAN Identifier that the system adds to Ethernet frames
that it sends to this gateway.
Priority This field displays the IEEE 802.1p priority (0~7) that is added to traffic sent to
this gateway.
Delete Select an entry’s Delete check box and click Delete to remove the entry.
Clicking Delete saves your changes to the AAM1212’s volatile memory.
The AAM1212 loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to start configuring the screen again.