ZyXEL Communications AAM1212-51, User Manual

Page: 192 / 435

AAM1212-51/53 Series User’s Guide
192 Chapter 27 2684 Routed Mode
Figure 98 2684 Routed Mode Example
Note the following.
• The CPE device’s WAN IP (192.168.10.200 in this example) must be in the same subnet
as the gateway’s IP address (192.168.10.102 in this example).
• The AAM1212's management IP address can be any IP address, it doesn't have any
relationship to the WAN IP address or routed gateway IP address.
• The AAM1212’s management IP address should not be in the same subnet as the one
defined by the WAN IP address and netmask of the subscriber’s device. It is suggested
that you set the netmask of the subscriber’s WAN IP address to 32 to avoid this problem.
• The AAM1212's management IP address should not be in the same subnet range of any
RPVC and RPVC domain. It will make the AAM1212 confused if the AAM1212
receives a packet with this IP as destination IP.
• The AAM1212’s management IP address also should not be in the same subnet as the one
defined by the LAN IP address and netmask of the subscriber’s device. Make sure you
assign the IP addresses properly.
• In general deployment, the computer must set the CPE device’s LAN IP address
(10.10.10.10 in this example) as its default gateway.
• The subnet range of any RPVC and RPVC domain must be unique.
27.2 2684 Routed PVC Screen
Use this screen to configure PVCs for 2684 routed mode traffic.
To open this screen, click Advanced Application , 2684 Routed Mode .