ZyXEL Communications AAM1212-51, User Manual

Page: 394 / 435

AAM1212-51/53 Series User’s Guide
394 Chapter 53 Virtual Channel Management
This command adds a PVC to handle 2684 routed mode traffic.
Note: You must use the
rpvc gateway set
command to configure the gateway’s
settings before you use the
rpvc set
command.
The following example adds a PVC for 2684 routed mode traffic. It is for DSL port 1, VPI 8,
VCI 35. It sets the DEFVAL profile for downstream traffic shaping and for upstream traffic
policing. The CPE device’s WAN IP address is 192.168.10.200 with a netmask of 32 and the
gateway’s IP address is 192.168.10.102.
53.7.6 RPVC Show Command
Syntax:
ras> adsl rpvc show <portlist>
DS vcprofile =
Assign a VC profile to use for this channel’s downstream traffic
shaping.
[,US
vcprofile]> =
Assign a VC profile to use for policing this channel’s upstream
traffic. The AAM1212 does not perform upstream traffic
policing if you do not specify an upstream VC profile.
<ip> =
The subscriber’s CPE WAN IP address in dotted decimal
notation.
/<netmask> =
The bit number of the subnet mask of the subscriber’s IP
address. To find the bit number, convert the subnet mask to
binary and add all of the 1’s together. Take “255.255.255.0” for
example. 255 converts to eight 1’s in binary. There are three
255’s, so add three eights together and you get the bit number
(24).
Make sure that the routed PVC’s subnet does not include the
AAM1212’s IP address.
<gateway ip> =
The IP address of the gateway to which you want to send the
traffic that the system receives from this PVC. Enter the IP
address in dotted decimal notation.
Figure 276 RPVC Set Command Example
ras> adsl rpvc set 1 8 35 DEFVAL,DEFVAL 192.168.10.200/32 192.168.10.102