ZyXEL Communications AAM1212-51, User Manual

Page: 63 / 435

AAM1212-51/53 Series User’s Guide
Chapter 5 Initial Configuration 63
C
H A P T E R
5
Initial Configuration
This chapter describes initial configuration for the AAM1212. See Appendix A on page 423
for various default settings of the AAM1212.
5.1 Initial Configuration Overview
This chapter shows what you first need to do to provide service to DSL subscribers.
5.2 Initial Configuration
This chapter uses the web configurator for initial configuration. See the CLI chapters for
information on the commands. Use Internet Explorer 6 and later versions with JavaScript
enabled.
1 Log in to the web configurator. See Section 4.3 on page 55 for instructions.
2 In the navigation panel, click Basic Setting , IP Setup . The IP Setup screen appears.
Figure 22 IP Setup
3
Use this screen to change the IP address, subnet mask, and default gateway IP address for
your network. Apply the settings.
Note: If you change the IP address of the AAM1212, after you click Apply IP setting ,
you have to use the new IP address to log into the web configurator again.
4
If your subscribers use VPI 0 and VCI 33 (the default for all of the DSL ports), go to step
13 . Otherwise, use the following steps to change the VPI and VCI settings for all of the
DSL ports.