9 / 121
User Manual 3000SP
Rev. 1.1 16/03/2021
Identification: MD-AL-GI-00
Rev. 1.1 of 16/03/2021 - Application: GID
Install and start the inverter according to the following instructions. Place the inverter on suitable load-
bearing supports with sufficient load capacity (such as walls or racks) and make sure that the inverter is
positioned vertically. Choose a suitable location for the installation of the electrical equipment. Make sure
there is sufficient space for heat dispersion and to accommodate future maintenance. Maintain adequate
ventilation and ensure that there is enough air circulation for cooling.
If you have problems with the packaging that could damage the inverter or if you find any visible damage,
immediately notify the transport company. If necessary, request assistance from an installer of photovoltaic
systems or from Zucchetti Centro Sistemi SpA. Transport of the equipment, especially by road, must be
carried out with vehicles suitable to protect the components (in particular, electronic components) against
violent knocks, humidity, vibrations, etc.
2.1.
General safety instructions
•
Installation and maintenance of the system must be carried out by qualified and certified electricians in
compliance with national regulations.
•
The 3000SP inverter must only be installed by qualified personnel and only after obtaining the
appropriate authorisations and permits as required by the local regulations.
•
DO NOT place explosives or flammable materials (e.g. gasoline, kerosene, oil, wood, cotton or similar)
near the batteries or the 3000SP inverter.
•
Before any maintenance, disconnect the DC (battery) and AC (grid and loads) connections, then wait at
least 5 minutes to allow the capacitors to discharge and to prevent accidental electrical discharges.
•
The 3000SP inverter must be completed disconnected (DC and AC side) during maintenance.
•
The 3000SP inverter may reach high temperatures during operation. Switch off the inverter and wait for
it to cool down before maintenance.
•
Keep children away from the batteries and inverter.
•
Do not open the front cover of the inverter. This will void the product warranty.
•
Damage to the inverter caused by incorrect installation, maintenance or use will not be covered by
warranty.
2.2.
Instructions on battery installation and maintenance
•
At the time of delivery, the battery is charged to at least 60%. Take all appropriate measures to prevent
the battery from short-circuiting during transport and installation.
•
Place the battery in a well-ventilated place. Do not install in a confined space or areas with poor air
circulation. The battery may be damaged if not properly ventilated.
•
Do not place the battery in very hot places, in direct sunlight or near heat sources. Overheating of the
