Zodiac RE 42 Series, Instructions For Installation And Use Manual

Page: 126 / 531

19
4.4 I Replacing the brushes
Are the brushes worn?
• Replace the brushes if the wear indicators are similar to example :
Remove the worn brushes
• Remove the tabs from the holes inside which they are fastened, then remove the brushes.
Position the new brushes.
• Fit the side without tabs under the brush holder (see figure ) .
• Roll the brush around its support, slide the tabs into the attachment holes and pull on the end of each tab until its
edge passes through the slit (see figure ).
• Cut the tabs using a pair of scissors for them to be level with the other blades (see figure ) .
EN