Maintenance
33
Mounting toolheads
Each toolhead has similar mounting method.
Find the bottom hooks
placed on the back of the
toolhead.
While placing the tool-
head be sure the hooks
are in the right place.
Gently mount new tool-
head placing it from the
back to the front in the
X-carriage.
Tighten the mounting
screw while gently push-
ing the toolhead forward
NOTE:
Tightening the mounting screw without pushing the toolhead to the front might
cause the connection between the toolhead and X carriage to be loose. This might cause
further errors in calibrations and printing processes.
NOTE:
Each time after changing the toolhead it is better to check if the connection is
correct. Lift the back of the toolhead and check if the rear hooks are not moving up and
down. If yes loose the front mounting screw and once again push and hold the toolhead
forward and tighten the mounting screw.
