Setting up ZMorph VX
30
Take out the filament roll
from the plastic bag and
slide it on the bar. Put the
bar with filament on the
holders.
Connect the power cable
to the socket.
Turn on the machine.
Apply 3D printing adhe-
sive to the center of the
worktable. Two layers
should be enough.
Loosen the screws to the
point where you can slide
the spool holder.
Slide the spool holder in
place.
Tighten the screws.
9.4 First use
When the machine is commissioned for the first time after transport, it is necessary to
perform an initial calibration process (for more information, see the
). During this process, the machine will heat up and it will be necessary to insert
material into the toolhead. After the calibration process, the machine is ready to perform
its first print.
