Product Manual - ZMORPH FAB
72
3D printing workflow
Choose ‘CALIBRATE’.
Choose ‘
AUTO 3-POINT
’. Wait
for the machine to heat up
and finish the probing.
To ensure the best calibration
result print calibration pattern.
Choose ‘START’.
Set the printing temperature
to the PLA material. Nozzle
200 °C, bed 60 °C.
To to that tap the gaps and
type the temperature on the
keyboard.
Wait for extruder to heat up.
When done tap ‘NEXT’.
Apply your choice.
Zmorph Fab calibration is
complete.
Clean the bed. Your machine
is ready for your first print!
Use the arrow buttons on the
screen to feed the material on
both sides of the extruder until
it start to pour out from the
nozzle. (it might take a couple
times), after that press the
‘NEXT’ button.
Wait for the machine to finish
printing pattern.
Look at printed lines and
select the best one on the
screen. A correct line is the
one that sticks to the table
after gently touching it with
the finger, but can be easily
ripped off with a fingernail.
NONE, REPEAT PRINTING
1
2
3
4
5
NEXT
Choose the best printed line
(numeration from le
ft
to right)
LOAD FILAMENT
LEFT
RIGHT
ALL
NEXT
BACK
Calibration complete!
DONE
LOAD
FILAMENT
CHANGE
TOOL
CALIBRATE
3D PRINTING
BACK
MORE
CALIBRATION
AUTO
3-POINT
BACK
MORE
MANUAL
CALIBRATION
In the last calibration step the machine
will print five lines as a final touch
SKIP
START
CALIBRATION
NEXT
BACK
CURRENT
TARGET
NOZZLE
BED
NEXT
BACK
TARGET
NOZZLE
BED
CURRENT
210
80mm
80mm
80mm
210
60
60
210
210
60
60
