Product Manual - ZMORPH FAB
28
Setting up Zmorph Fab
9. Setting up Zmorph Fab
9.1 Location requirements
After unpacking, place the machine in a suitable location.
▪ The machine should be placed on a stable, flat surface with sufficient space above the machine.
▪
Do not cover the machine with any materials during operation.
▪
The machine should not be exposed to moisture.
▪
The electrical installation of Zmorph Fab requires it to be connected to a grounded wall outlet.
▪
Do not use extension cords.
▪ Leave a 20 mm (minimum) space from the wall, for proper ventilation.
▪ Leave a 40 mm (minimum) space from the right side for better access to the SD card slot (or 60mm
for the HEPA Filtration system cover) .
▪
It is recommended that the room in which the machine is located should be well ventilated, as
hazardous vapors may escape from the machine during operation.
min.
50mm
550 mm
550 mm
750 mm
750 mm
660 mm
min.
60 mm
