Product Manual - ZMORPH FAB
69
Set the printing temperature
to the PLA material., Nozzle
210 ˚C, bed 60 ˚C.
To do that tap the gaps and
type the temperature on the
screen.
Wait for the extruder to heat
up. When done tap ‘NEXT’.
Use the arrow buttons on the
screen to feed the material on
the extruder until it start to pour
out from the nozzle. (it might
take a couple times), after that
press the ‘NEXT’ button.
Wait for the machine to finish
printing pattern.
NOTE:
by pressing the
‘SKIP’ button the user is
approving the automatic
calibration without visual
validation. After that the
calibration process ends.
Look at the printed lines and
select the best one on the
screen. A correct line is the
one that sticks to the table
after gently touching it with
the finger, but can be easily
ripped off with a fingernail.
Apply your choice.
Zmorph Fab calibration is
complete.
NEXT
BACK
CURRENT
TARGET
NOZZLE
BED
LOAD FILAMENT
NEXT
BACK
NONE, REPEAT PRINTING
1
2
3
4
5
NEXT
Choose the best printed line
(numeration from le
ft
to right)
NEXT
BACK
TARGET
NOZZLE
BED
CURRENT
In the last calibration step the machine
will print five lines as a final touch
SKIP
START
CALIBRATION
Calibration complete!
DONE
3D printing workflow
Each one of those lines is printed on a slightly different height (+/- 0.05 mm) with the middle line
being the result of the automatic calibration process.
NOTE
15mm
210
210
60
60
210
210
60
60
