Zirkon zahn P4000 PRINTER, Operation And Maintenance Manual

Page: 73 / 80

01
03
05
02
06
04
73
CHAPTER
L300 POST CURING LAMP
ZIRKONZAHN – P4000 PRINTER OPERATION AND MAINTENANCE MANUAL – VERSION: 20/09/2022
CLEANING AND POST-CURING THE MODEL
After removing the model from the printer's building plate, clean, wash and post-process the
RTKPVGFQDLGEVCEEWTCVGN[VJGYQTMƀQYUJQYPDGNQYKUTGHGTTGFVQVJG2TKPVGT4GUKP9CVGTDCUGF
Beige. If other resins are used, follow the corresponding resins' instructions).
Fill a washing-up bowl with clean water and rinse
the 3D model.
IMPORTANT: In case of hollow models, clean the
inner parts to remove any excess resin.
This step is very important to avoid cracking of
models or sticky surfaces.
IMPORTANT: It is recommended to place the models
in a little vat inside the Ultrasonic Cleaner, in order to
isolate them and avoid contact with the water in the
basket. Use only water at room temperature.
Brush the model gently with a soft-bristle brush
until its surface is clean (clean with water or alcohol
depending on the resin used).
Fill the Ultrasonic Cleaner basket with clean water,
switch it on and immerse the model for 10 minutes.
Remove the 3D model from the Ultrasonic Cleaner ...