Zirkon zahn P4000 PRINTER, Operation And Maintenance Manual

Page: 74 / 80

08 07
09
74
CHAPTER
L300 POST CURING LAMP
ZIRKONZAHN – P4000 PRINTER OPERATION AND MAINTENANCE MANUAL – VERSION: 20/09/2022
... and dry it with compressed air.
Make sure that the model is totally dry and cure it in
the L300 Post-Curing Lamp for 10 minutes.
Do not forget to dry inner parts!
IMPORTANT:
The water used to clean the model may contain plastic
parts. For this reason, we recommend not to empty the basin
directly in the sink, in order to reduce enviromental impact
and avoid damages to the sink.
Put the dirty water in the transparent container and place it
in a bright area till the resin becomes solid under sunlight
exposure (it settles on the bottom). Then, fi lter the water
using the paper fi lters included in the Cleanig Kit and
proceed with disposal according to national and local
regulations.